10 Steps to Install a Mechanical Seal Correctly and Avoid Early Failure

The majority of mechanical failures come from installation grinding.Compliance with a clear process increases the life of the failure.

Before installing

• Check the pump: axle reversibility, center deviation, axle vertical inertia and axle condition.
• Clean the axis and chamber, check for scratches and bavia.
• Compare the code, material and size with the drawings.

While installing

• Keep the face clean, do not touch the hand directly on the sealed surface.
• Lubricate ice cream with compatible substances, without using inappropriate oils.
• Install the cartridge according to the instructions, only remove the localization clamp after finishing.
• Cut the hair at the right time.

After installing

• Discharge and supply sufficient fluid to the chamber before running.
• Check the auxiliary system and discharge.
• Run test, track leakage, temperature and vibration.

attention to

Always follow the manufacturer’s instructions for each line. Training installation technicians is an effective investment.

Source of reference.

Synthesized from common technical practice in mechanical debris installation.